Vanquish - E
Click
here to download/view PDF version
Product Description
VANQUISH - E is a water based acrylic copolymer
flexible coating that performs to BS476 parts 6 & 7
for Class 0 rated fire propagation & surface spread
of flame. Designed for asbestos encapsulation, it is
useful in a number of other applications. VANQUISH
- E contains no VOCs.
Typical Applications
- Asbestos encapsulation ( in conjunction with Vanquish
- S water based asbestos impregnation sealer )
)
- Vapour check coating
- As a stand alone Class 0 fire resistant coating
Processing
VANQUISH - E is easily applied by spray, brush
or roller. Graco airless spray equipment is recommended
for machine process. STIR BEFORE USE.
Storage, Handling and Personal Protection
- should be stored in dry conditions at a temperature
around 20ºC.
VANQUISH - E has a shelf life of
6 months.
- Opened, part used containers must be resealed immediately
after use.
The recommendations in our Safety Data Sheet for this
product must be followed at all times. More general information
is included in our publication “A Guide to the Safe Handling
of Polyurethane Chemicals” and in the following Technical
Data Sheet that is available on request:
- Fire safety when Storing, Handling and Installing
Polyurethane Foam.
Additional Information
All surfaces should be sound, clean, dry and free from oil or grease. Do not use in wet or
freezing conditions.
For asbestos encapsulation, i.e. treatment of asbestos containing material ( ACM ) in good
condition, which can be safely left in situ, first use Vanquish - S water based asbestos
impregnation sealer to permeate the material and seal in any loose fibres. ( Alternatively, a
solution of Vanquish - E diluted with clean cold water may be used for the penetrating coat:
ask Isothane technical staff for advice ). Follow the instructions for use on the separate
Technical Data Sheet for Vanquish - S.
The penetrating coat should be left until dry ( usually 2 - 4 hrs depending on ambient
conditions ) before the encapsulation coating VANQUISH - E is applied to the entire surface,
ensuring any small crevices are properly coated. Areas subject to mechanical damage such
as joints may require additional protection with a reinforcement membrane.
Coverage guidance: one coat at a rate of 1 litre per
square metre for a dry film thickness of at least 0.7mm.
Typical Properties
| UV resistance |
Good |
| Light reflectivity |
Good |
| Adhesion |
Excellent |
| Solids content |
70 % |
| Tensile strength |
2 MN/m² |
| Elongation |
548 % |
| Service temperature range |
-20°C to 50°C |
| |
|
| Drying time |
2 - 12 hours |
| Toxicity |
Non - toxic |
| Flammability |
Non - flammable |
Asbestos Encapsulation
|
HOME ||
ASK A QUESTION/OFFER FEEDBACK ||
CONTACT US ||
LINKS ||
SITE INDEX ||
